|
| From: | Florian Kiera |
| Subject: | ubxtool configuration |
| Date: | Mon, 25 May 2020 16:50:43 +0200 |
| User-agent: | Mozilla/5.0 (X11; Linux x86_64; rv:68.0) Gecko/20100101 Thunderbird/68.8.1 |
Heyo all,
I want to configure the rover and base M8P with ubxtool now. On
my rover's computer I run "gpsd -n /dev/ttyACM0 -G
ntrip://root:root@192.168.7.101:2101/BASIS -N" to receive
correction data (RTCM3).
How can I address /dev/ttyACM0 with ubxtool (to configure it)?
Just using "ubxtool -p CONFIG" will end up with
"{"class":"ERROR","message":"No path specified in DEVICE, but
multiple devices are attached."}"
Using "ubxtool -f /dev/ttyACM0 -p RESET" will end up with:
ubxtool: failed to open serial port
"/dev/ttyACM0"
ubxtool: Your computer has the serial ports:
/dev/ttyS0: ttyS0
/dev/ttyACM0: u-blox GNSS receiver
Because its used already probably... Still there must be a way to
achieve it which I do not see. Is just ignoring the "ubxtool -p
CONFIG" error the solution? Not really beautiful is it?
Regards Florian
| [Prev in Thread] | Current Thread | [Next in Thread] |