[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Problem in configure

From: James Shewey
Subject: Re: Problem in configure
Date: Sun, 12 Oct 2008 21:08:09 -0400

This may be a nevermind situation. I was compiling on a 64 bit system. Changing the line described to if test "$grub_cv_prog_target_cc" = xno; then" Resulted in an error stating that neither start or _start was defined. This led me to the following post: This led me to try compiling on my 32 bit system which worked just fine.

On Sun, Oct 12, 2008 at 8:29 PM, James Shewey <address@hidden> wrote:
I believe that line 6938, which reads:

if test "x$grub_cv_prog_target_cc" = xno; then

May contain an error. Perhaps this should read

if test "$grub_cv_prog_target_cc" = xno; then


if test "$grub_cv_prog_target_cc" = no; then



reply via email to

[Prev in Thread] Current Thread [Next in Thread]