Re: Re: [PATCH 2/2] gnu: multiqc: Update to 0.8.

[Ra]

Hi Ben,

thanks I will investigate. Does it mean that multiqc is in stand by for now ?

On Fri, Dec 23, 2016 at 2:30 PM Ben Woodcroft <address@hidden> wrote:

Hi Raoul,

Thanks for the patches.

On 19/12/16 07:36, Ra wrote:
> [PATCH] gnu: multiqc: Update to 0.8.
> is [PATCH 1/2] for this message, sorry for the mistake.
> Running multiqc without [PATCH 2/2] systems say that matplotlib
> requires nose>=0.11.1, so I added it to the propagated inputs.
I notice that 0.9 is out too, so I tried updating to that version. I
also added "python-nose" as a native-input rather than a
propagated-input since it is only used at build time.

However, the tests fail with this error:

FileNotFoundError: [Errno 2] No such file or directory: 'git'

The check phase is still successful so it doesn't stop - this problem is
being fixed by others. I added a patch to ignore the FileNotFoundError,
but then after all that the tests fail. Would you mind investigating
further, perhaps by raising an issue on the multiqc GitHub? My efforts
so far are in the attached patch.

Thanks, ben.