[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: Getting started with GWL 0.3.0
From: |
Konrad Hinsen |
Subject: |
Re: Getting started with GWL 0.3.0 |
Date: |
Tue, 23 Mar 2021 16:51:59 +0100 |
Konrad Hinsen <konrad.hinsen@fastmail.net> writes:
> Unfortunately, my first attempt didn't get very far:
>
> $ guix workflow run hello.w
> guix: workflow: command not found
> Try `guix --help' for more information.
That was with Guix installed under Ubuntu. Today I tried on a VM
running Guix System. Result: the same.
So... how do you all actually use GWL? Should I try to build/run
from source? I don't see any instructions for that either, nor
any pointer to the source repo.
Cheers,
Konrad.
- Re: Getting started with GWL 0.3.0, (continued)
- Re: Getting started with GWL 0.3.0, Konrad Hinsen, 2021/03/22
- Re: Getting started with GWL 0.3.0, zimoun, 2021/03/22
- Re: Getting started with GWL 0.3.0, Konrad Hinsen, 2021/03/22
- Re: Getting started with GWL 0.3.0, zimoun, 2021/03/22
- Re: Getting started with GWL 0.3.0, Konrad Hinsen, 2021/03/23
- Re: Getting started with GWL 0.3.0, Ricardo Wurmus, 2021/03/23
- Re: Getting started with GWL 0.3.0, Roel Janssen, 2021/03/23
- Re: Getting started with GWL 0.3.0, zimoun, 2021/03/23
- Re: Getting started with GWL 0.3.0, Konrad Hinsen, 2021/03/24
- Re: Getting started with GWL 0.3.0, zimoun, 2021/03/24
Re: Getting started with GWL 0.3.0,
Konrad Hinsen <=
Re: Getting started with GWL 0.3.0, Konrad Hinsen, 2021/03/24