[Help-glpk] Knowing when iterations will end

[leowl]

Again, thanks to all and especially Andrew that I am able to get glpk running.

The simulations work fine for smaller data sets but when it comes to the 
largest data set that resulted in ne=160,000 and ia with a size 200k elements, 
the simulations seem to take very long and i am not sure if it is because I am 
doing something wrong or that I should give it more time.

After 7+ hours of simulation on a Pentium 1.5 GHz with 512MB RAM, this is what 
appeared on the DOS output:

257000:    objval = 0.000000000e+000    infeas = 1.000000000e+000 <0>

Kindly note that the rightmost entry started out at <25,000> or there abouts 
and it has been showing <0> for a long time.

The simulations went exceedingly well for smaller data sets but this one was 
problematic. Can someone advise me what this means? Should I let the simulation 
run for another 7 hours? Or has something went wrong? 

Thanks in advance!

--
This message was sent on behalf of address@hidden at openSubscriber.com
http://www.opensubscriber.com/messages/address@hidden/topic.html