[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Help-gnucap] strange error message if a subcircuit definition is wr
Re: [Help-gnucap] strange error message if a subcircuit definition is wrong
Sun, 4 Nov 2007 19:43:43 +0100
KMail/1.9.6 (enterprise 20070904.708012)
On Sonntag, 4. November 2007, al davis wrote:
> The real problem in your case is that you left out the ".ends"
> on your subckt, so it appears that the main circuit is part of
> the subcircuit. Therefore there is no main circuit.
> There was no warning about this because the ".end" at the
> end of the file is close enough to .ends (and accepted by some
> Spice versions).
Oh thanks, I haven't noticed that error. I just was so fixed to the head
of the subcircuit file where the subcircuit name is the same than the
Then of course the given error message is correct.