[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Help-gnucap] Re: Scientific/engineering notation
From: |
a r |
Subject: |
Re: [Help-gnucap] Re: Scientific/engineering notation |
Date: |
Fri, 30 Nov 2007 02:55:49 +0000 |
The error can be solved by decreasing the minimum timestep (default:
1e-12) by setting dtmin option:
.option dtmin=1e-13
Still, simulation using backward Euler method gives better results and
runs faster due to the lack of ringing. Is there any method to
"stabilize" the simulation using trapezoid method?
-r.
On Nov 30, 2007 2:03 AM, Leandro Marsó <address@hidden> wrote:
> 2007/11/29, a r <address@hidden>:
> > When using a TSMC 0.25 MOSIS models (level=49) setting the time step
> > below 0.1ns like below:
> >
> > .tran 0.01n 40n
> >
> > causes following problems.
> >
> > storage element step control error:Cgs.Mn1.xgate 1e-12
> > using Euler, disabling time step control
> >
> > With timestep of 0.1ns the simulation runs fine but the numerical
> > ringing is very visible.
> >
> > Any idea?
> >
> > -r.
>
> Hello -r,
> be carefull with the units in the length and width of the channel, it
> is in meter units. If it is not the problem, you could try to isolate
> the problem with a small circuit and paste it and send it to the list.
> good luck!
> Leandro
>
>
> _______________________________________________
> Help-gnucap mailing list
> address@hidden
> http://lists.gnu.org/mailman/listinfo/help-gnucap
>
Re: [Help-gnucap] Scientific/engineering notation, al davis, 2007/11/29