[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[Help-gnucap] diode models

From: John Griessen
Subject: [Help-gnucap] diode models
Date: Fri, 22 Jul 2016 16:49:52 -0500
User-agent: Mozilla/5.0 (X11; Linux x86_64; rv:45.0) Gecko/20100101 Icedove/45.1.0

I've used the 1n4004 model in a simulation and would like to put in a more 
accurate representation
of the high voltage diode I use.

Where is good documentation on spice models, or is it a good time to start 
using gnucap
native models to enter data from a part datasheet?

If native is good to use, the
page does not go into it.  Is there more documentation on native model 

If this is not commonly done, then I will work around it by a crude 
substitution of as many 1n4004 diodes as model the volt drop.
I wonder if that will give trouble calculating... will the volt drop spread 
evenly...probably yes since identical models.

reply via email to

[Prev in Thread] Current Thread [Next in Thread]