[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Herd works with network not at all

From: znavko
Subject: Re: Herd works with network not at all
Date: Sun, 20 Dec 2020 21:51:01 +0000

You know, after I increased delay after services were stopped 
to 8 seconds
and also placed dealy 8 seconds between start of wpa-supplicant and start of 
My reconnections are working nice.
I think the reason is the delay, but it is just practical knowledge, not 

December 20, 2020 9:38 PM, "znavko--- via" <> wrote:

> Hello, Guix! My simple script is just using for reconnect to Internet 
> provider from those 2 I use.
> It works bad.
> I have internet after PC was booted.
> And then I have to use this script to connect to another provider (just for 
> to change IP).
> I run my script with `# ./wpa bee` and it does things but I have no Internet 
> and ping does not find
> host
> This script stops two services in my system
> networking
> wpa-supplicant
> And then runs them with new wpa-supplicant config.
> I placed `sleep 2` there between stopping and running services. But did not 
> get it works fine.
> My new config and using of another Internet provider works after reboot.
> Also it works without herd just with
> # wpa_supplicant -B -i wlp2s0 -c /etc/wpa_supplicant/wpa_supplicant.conf
> # dhclient -v
> I cannot see errors in herd services. Herd services works badly, but hand 
> made connection works
> fine.
> Is the deal over 2 seconds of delay? Do I need to increase delay period?
> Please, what do I need to consider?

reply via email to

[Prev in Thread] Current Thread [Next in Thread]