[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: simulation results from octave wrong!!!
From: |
Dmitri A. Sergatskov |
Subject: |
Re: simulation results from octave wrong!!! |
Date: |
Thu, 2 Aug 2007 13:18:33 -0500 |
On 8/2/07, Freddie Hamatanga <address@hidden> wrote:
>
> I installed correctly Octave 2.9.13 with the Signal and Communication
> toolboxes, but when I run a Wireless LAN simulation programme, the results
> are very different from those obtained from matlab. What could be the
The results actually not that different. As you can see, the sum of
Octave's output
and Matlab's output (for BER parameter) is 1.
Now you just have to figure out why it is.
(And then we will try to make sure it does not happen again.)
Regards,
Dmitri.
--