[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [igraph] [Igraph] Help

From: patricia
Subject: Re: [igraph] [Igraph] Help
Date: Sat, 3 May 2014 03:00:45 +0300

During the installation procedure library IGRAPH using cygwin, when running the command <"make check"> at the end of several test execution finished with status <failed>. I wonder if this may cause a problem (error) future or if that act is considered normal. 

If not, what should I run correction procedures? 

Thank you

reply via email to

[Prev in Thread] Current Thread [Next in Thread]