Re: question about org-link gnus message and gnus registry

[physiculus]

Am Do, 2021-12-02, 11:20 -0800, Eric Abrahamsen <eric@ericabrahamsen.net> 
schrieb:

hello,
the version is 1.6.9 from elpa, installed today.

this is the backtrace:
Debugger entered--Lisp error: (void-function second)
  signal(void-function (second))
  gnorb-org-setup-message(("nnimap+GMail:gnus#87o860krsm.fsf@googlemail.com") 
nil nil nil nil nil nil "65281282-7850-4f1f-b9e3-e18413932a1a")
  gnorb-org-handle-mail(nil)
  funcall-interactively(gnorb-org-handle-mail nil)
  call-interactively(gnorb-org-handle-mail record nil)
  command-execute(gnorb-org-handle-mail record)
  execute-extended-command(nil "gnorb-org-handle-mail" nil)
  funcall-interactively(execute-extended-command nil "gnorb-org-handle-mail" 
nil)
  call-interactively(execute-extended-command nil nil)
  command-execute(execute-extended-command)

hope it helps

regards
Jens

> physiculus <physiculus@gmail.com> writes:
>
>> Am Mi, 2021-12-01, 13:47 -1000, Bob Newell <bobnewell@bobnewell.net> schrieb:
>>
>> hello,
>> thanks for the reply.
>> i gave gnorb a try, but if i move a message,  that is linked with gnorb,
>> i got the following error:
>> gnorb-org-setup-message: Symbol’s function definition is void: second
>>
>> do you know what it means?
>
> All calls to `second' in the Gnorb codebase should have been replaced by
> `cl-second' years ago (like in 2014). Can you tell me your Gnorb
> version, and also run M-x toggle-debug-on-error and trigger the error
> again, then send me the backtrace?
>
> Thanks,
> Eric
>
>

-- 
Jens Reimer