[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [libredwg] Segmentation Fault

From: R. van Twisk
Subject: Re: [libredwg] Segmentation Fault
Date: Thu, 23 Jun 2011 06:33:22 -0500

On Jun 23, 2011, at 2:20 AM, Davinder Kumar wrote:

> Hello everyone,
> I am using libredwg.Whenever i used convert command like
> ./testSVG input.dwg > output.svg
> it gives following error
> "Segmentation fault"

David, what version of dwg is that?
I noticed that DWG version 2010 (I believe)
will always segfault.

THis was tested with a draftsight export.


> -- 
> Dont hurt the web, use open standards

reply via email to

[Prev in Thread] Current Thread [Next in Thread]