--- configure	2003-11-19 07:45:01.000000000 +0000
+++ myconfigure	2003-11-19 07:44:53.000000000 +0000
@@ -16088,11 +16088,15 @@
             ac_config_commands="$ac_config_commands libtool-tags"
 
 
+echo "1ac_aux_dir: $ac_aux_dir"
+echo "1srcdir: $srcdir"
 case $ac_aux_dir in
   $srcdir)   ltmain=./ltmain.sh ;;
   $srcdir/*) ltmain=`expr "$ac_aux_dir" : "$srcdir/\(.*\)"`/ltmain.sh ;;
 esac
+echo "1ltmain1: $ltmain"
 test -f "$ltmain" || ltmain="$ac_aux_dir/ltmain.sh"
+echo "1ltmain2: $ltmain"
 
 
 # This can be used to rebuild libtool when needed
@@ -17826,11 +17830,15 @@
     ;;
   esac
 
+echo "2ac_aux_dir: $ac_aux_dir"
+echo "2srcdir: $srcdir"
   case $ac_aux_dir in
   $srcdir)   ltmain=./ltmain.sh ;;
   $srcdir/*) ltmain=`expr "$ac_aux_dir" : "$srcdir/\(.*\)"`/ltmain.sh ;;
 esac
+echo "2ltmain1: $ltmain"
 test -f "$ltmain" || ltmain="$ac_aux_dir/ltmain.sh"
+echo "2ltmain2: $ltmain"
 
   # We use sed instead of cat because bash on DJGPP gets confused if
   # if finds mixed CR/LF and LF-only lines.  Since sed operates in
@@ -19096,11 +19104,15 @@
 
  ;;
     libtool-tags )
+echo "3ac_aux_dir: $ac_aux_dir"
+echo "3srcdir: $srcdir"
     case $ac_aux_dir in
   $srcdir)   ltmain=./ltmain.sh ;;
   $srcdir/*) ltmain=`expr "$ac_aux_dir" : "$srcdir/\(.*\)"`/ltmain.sh ;;
 esac
+echo "3ltmain1: $ltmain"
 test -f "$ltmain" || ltmain="$ac_aux_dir/ltmain.sh"
+echo "3ltmain2: $ltmain"
 
     if test -f "$ltmain"; then
       if test ! -f "${ofile}"; then