[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: Problems with libtool 2.2.2 and /bin/sh pointing to dash
From: |
Peter O'Gorman |
Subject: |
Re: Problems with libtool 2.2.2 and /bin/sh pointing to dash |
Date: |
Tue, 22 Apr 2008 10:01:55 -0500 |
User-agent: |
Thunderbird 2.0.0.9 (X11/20071115) |
Gary V. Vaughan wrote:
>> Was this behaviour present in libtool 1.5?
>
> No it wasn't, because libtool was generated in a two stage process which
> required
> calling ./libtool --config directly.
Hi Gary,
I think you may be wrong. You can check the value of libtool variables
in configure for libtool > 1.4. In 1.3 and earlier there was a separate
ltconfig script which was run, so those variables were not available.
With 1.4 libtool's checks became part of the configure script itself, so
anything after AC_PROG_LIBTOOL can check the variables values.
With 2.x, of course, it is preferred to use the vars directly, creating
libtool just to check these is expensive and pointless.
Peter
--
Peter O'Gorman
http://pogma.com
- Problems with libtool 2.2.2 and /bin/sh pointing to dash, Richard Purdie, 2008/04/21
- Re: Problems with libtool 2.2.2 and /bin/sh pointing to dash, Ralf Wildenhues, 2008/04/22
- Re: Problems with libtool 2.2.2 and /bin/sh pointing to dash, Gary V. Vaughan, 2008/04/22
- Re: Problems with libtool 2.2.2 and /bin/sh pointing to dash, Bob Friesenhahn, 2008/04/22
- Re: Problems with libtool 2.2.2 and /bin/sh pointing to dash, Bob Friesenhahn, 2008/04/22
Re: Problems with libtool 2.2.2 and /bin/sh pointing to dash, Ralf Wildenhues, 2008/04/22