MIPS unwind only backtraces 2 local levels...

[Story, Lenny]

Greetings,

The backtraces on my MIPS target are only going two levels, which happen to be declared inside my local file.

Because of its size, the target is stripped of the dwarf .debug_ * seconds, and the .symtab.  Its just too big to load with symbols included.  I am only looking to get the frame addresses from the target, and plan on performing the symbol resolution off target.

What should I look for in trying to see the trace back to main ? 

Thanks !

-Lenny

This e-mail message and any files attached may contain information that iRobot Corporation considers confidential and/or proprietary or may later designate as confidential and proprietary. If you are not the intended recipient, please contact the sender and delete the email immediately. Unauthorized use or distribution is strictly prohibited.