[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[Lilypond-auto] [LilyIssues-auto] [testlilyissues:issues] #5247 add dyna

From: Auto mailings of changes to Lily Issues via Testlilyissues-auto
Subject: [Lilypond-auto] [LilyIssues-auto] [testlilyissues:issues] #5247 add dynamic n for “niente” to feta
Date: Fri, 29 Dec 2017 19:47:46 -0000

the CPU_COUNT can be used for any of the make commands.

Note that what you did and what I do to test the patch are not the same here.

Here's my work flow from a clean $LILYPOND_GIT; in case it helps you.

mkdir build
./autogen --noconfigure
cd build
../configure --disable-optimising
make -j6 CPU_COUNT=6
make -j6 CPU_COUNT=6 test-baseline
apply patch (however you do that)
make -j6 CPU_COUNT=6 clean
make -j6 CPU_COUNT=6
make -j6 CPU_COUNT=6 check

(then I do a make doc after that).

If any of the makes fails after applying the patch, then I try to report what I get but sometimes it is hard because of the multi-jobs I run when testing.

[issues:#5247] add dynamic n for “niente” to feta

Status: Started
Created: Wed Dec 27, 2017 01:49 PM UTC by Malte Meyn
Last Updated: Fri Dec 29, 2017 01:53 PM UTC
Owner: Malte Meyn

add dynamic n for “niente” to feta

For a discussion see the following blog posts and their comment

The first post mentions also italic numbers for fingerings/tuplets which
Feta doesn’t contain yet (issue 5074).

The “niente” n is a copied and modified version of the “mezzo” m code.

Contains also:
add dynamic script \n command for “niente”

Sent from because address@hidden is subscribed to

To unsubscribe from further messages, a project admin can change settings at Or, if this is a mailing list, you can unsubscribe from the mailing list.

Check out the vibrant tech community on one of the world's most
engaging tech sites,!
Testlilyissues-auto mailing list

reply via email to

[Prev in Thread] Current Thread [Next in Thread]