[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[Lilypond-auto] [LilyIssues-auto] [testlilyissues:issues] Re: #5646 Swit

From: Auto mailings of changes to Lily Issues via Testlilyissues-auto
Subject: [Lilypond-auto] [LilyIssues-auto] [testlilyissues:issues] Re: #5646 Switch to Python 3.x
Date: Mon, 27 Jan 2020 11:33:47 -0000

Here's the thing ... If there are any 'makey' type files, then as far as my experience goes I cannot run the 'proper' tests. I.e. if I make, make check and then apply patches (especialy with AC files) I get errors about file is newer or something (I forget which). So what I do is exercise as much as I can and I do a test-baseline which at least runs the reg tests just without any diffs to compare. I am not sure how to get around patching build/make files after we have built LP.
Of course if this is completely wrong then I need to adjust my tests.

[issues:#5646] Switch to Python 3.x

Status: Started
Created: Thu Dec 19, 2019 06:15 PM UTC by Jonas Hahnfeld
Last Updated: Sun Jan 26, 2020 01:38 PM UTC
Owner: Jonas Hahnfeld

Switch to Python 3.x

Find and require at least Python 3.5 which will allow us to address
some deprecation warnings, most notably about the 'imp' module.
The major version 3.5 was first released in September 2015 and should
be available in all major distributions, including Ubuntu LTS 16.04 and
18.04 as well as CentOS/RHEL 7.x and 8.x.

Invidivial changes:

Full patch (with Patch Sets)

Sent from because address@hidden is subscribed to

To unsubscribe from further messages, a project admin can change settings at Or, if this is a mailing list, you can unsubscribe from the mailing list.

Testlilyissues-auto mailing list

reply via email to

[Prev in Thread] Current Thread [Next in Thread]