[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: Stagnant regression test output
From: |
Han-Wen Nienhuys |
Subject: |
Re: Stagnant regression test output |
Date: |
Sat, 24 Feb 2018 10:12:31 +0100 |
There used to be a test that created a random layout (which should
always trigger), just to make sure that the regression test comparison
itself was working. Has this disappeared?
On Fri, Feb 16, 2018 at 1:49 PM, Dan Eble <address@hidden> wrote:
> Last night, I noticed that the log output for my local regression tests did
> not hold the updated output I expected after test-clean, check. It still
> held old output that did not match what my rebuilt lilypond binary produced
> in a manual run on the test input. I ended up deleting my whole build
> directory and starting over.
>
> At this point, I don’t have any reason to believe that there is a problem
> affecting other people; however, I don’t have evidence to the contrary
> either. It’s going to take me some time to get to the bottom of it. My
> hypothesis is that there’s yet another undiscovered problem with my using a
> separate, read-only source directory, but I want to warn everyone to pay
> attention as you test, just in case it’s not limited to my environment.
>
> Regards,
> —
> Dan
>
>
> _______________________________________________
> lilypond-devel mailing list
> address@hidden
> https://lists.gnu.org/mailman/listinfo/lilypond-devel
--
Han-Wen Nienhuys - address@hidden - http://www.xs4all.nl/~hanwen