did 'make web-clean' still fails

[David Bobroff]

> > I've just updated from CVS (ChangeLog 1.985) and built Lilypond
> 1.7.21. 
> > That was fine.  Doing 'make web-doc' resulted in an exit with an
> error. 
> > I've been getting an error on 'make web-doc' for some time now but
> > Han-Wen, I think, said that 'make web-doc' is sure to work for
> tarball
> > releases but not always for current CVS, so I haven't complained. 
> This
> > CVS updated is labelled "release commit" so I thought it was time to
> > speak up again.  The end of the console output follows.
> 
> do make web-clean before you run make web-doc.

Ok, I did 'make web-clean' before 'make web-doc' but it still failed,
though with a different failure.  Here is the end of the output.

-David Bobroff

This is TeX, Version 3.14159 (Web2C 7.3.1)
 
(/home/lily-cvs/lilypond/Documentation/user/out-www/lilypond.texi
! Undefined control sequence.
l.2 \key
         c \minor r8 c16 b c8 g as c16 b c8 d | g,4
! Undefined control sequence.
l.2 \key c \minor
                  r8 c16 b c8 g as c16 b c8 d | g,4
(lily-38683535.tex
(/home/lily-cvs/lilypond/share/lilypond/tex/source/lilyponddefs.tex
(/home/lily-cvs/lilypond/share/lilypond/tex/generate/feta20.tex)
(/home/lily-cvs/lilypond/share/lilypond/tex/source/lily-ps-defs.tex)))
Overfull \hbox (21.59029pt too wide) in paragraph at lines 1--10
[]\tenrm @example c r8 c16 b c8 g as c16 b c8 d | g,4 @end ex-am-ple
@tex  [][]
[][] |
[1] )
(see the transcript file for additional information)
Output written on lilypond.dvi (1 page, 1648 bytes).
Transcript written on lilypond.log.
/usr/bin/texi2dvi: tex exited with bad status, quitting.
/usr/bin/texi2dvi: see lilypond.log for errors.
make[2]: *** [out-www/lilypond.dvi] Error 1
rm out-www/music-glossary.texi
make[2]: Leaving directory `/home/lily-cvs/lilypond/Documentation/user'
make[1]: *** [WWW] Error 2
rm out-www/index.texi
make[1]: Leaving directory `/home/lily-cvs/lilypond/Documentation'
make: *** [web-doc] Error 2
address@hidden lilypond]#