Hi Again,
I'm trying to typeset one of my songs so it will fit on a CD case
insert. I presently print one side of a piece of paper with the
label, cut it to size and fold it in half to insert in the jewel
case. I'd like to have the score to one of my songs printed on the
side that's presently blank.
Space is at a premium, so I'm fiddling extensively with all the
spacing variables I can. I'm now able to fit my song in the desired
space, but only by using:
#(set-global-staff-size 11.22)
As recommended in the doc at 11.2.1 Setting the staff size.
This makes the notes very small and hard to read. However, there is
a lot of unused space between the upper and lower staffs of my
PianoStaff. I can't figure out how to adjust it - if I could make it
smaller, I could make the staff size above larger, and the notes
easier to read.
My Lilypond source is as follows. You'll find Emergence.ly at:
http://www.geometricvisions.com/music/
I'm very much a beginner, but an enthusiastic one at finally being
able to score my music. Thanks for your help!
Michael David Crawford
address@hidden
\version "2.11.18" % necessary for upgrading to future LilyPond versions.
#(set-default-paper-size "case-insert" 'landscape)
#(set-global-staff-size 11.22)
\paper {
line-width = #(- paper-width (* 10 mm))
between-system-space = 10\mm
ragged-last-bottom = ##f
ragged-bottom = ##f
head-separation = #0
page-top-space = #10
head-separation = 4\mm
}
\include "Emergence.ly"
_______________________________________________
lilypond-user mailing list
address@hidden
http://lists.gnu.org/mailman/listinfo/lilypond-user