Re: String number indication, cross-staff kneed beam

[Keith OHara]

Nick Payne <nick.payne <at> internode.on.net> writes:
> 
> See below. The output is fine until I add the '\3' string number 
> indication to the last note on the lower stave, at which point the 
> output gets garbaged. The problem doesn't happen if the string number 
> orientation is set to down rather than up, nor does it happen with a 
> kneed beam on a single staff with the string number orientation up.
> 

>      \stemUp
>      \change Staff = "high"
>      \stemDown bes32[
>      \change Staff = "low"
>      \stemUp <a-1> <c-4\3>16]
> }

This bug is known (issue 1300) but I don't know of a good general workaround,
other than setting the stem directions and beam positions by hand 
(section 4.5.2, Fixing overlapping notation).