[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: printed bars thickness inconsistencies

From: Janek Warchoł
Subject: Re: printed bars thickness inconsistencies
Date: Wed, 27 Jul 2011 20:22:16 +0200

2011/7/26 Jean-Alexis Montignies <address@hidden>:
> It looks much better on screen ( MacOS X system renderer) and on 
> Xerox Phaser 5400!
> Remains a little bit of smearing on the top of the staff, but this is much 
> less than before and could be some rounding/smoothing issue in the renderers. 
> More specifically, on screen, the horizontal edge of the barline rect looks 
> not smoothed, while the vertical edge is. Don't know enough about PS if this 
> can be controlled, or if it's really an issue (in any case minor).
> Thickness looks consistent now.

Good, thanks for reporting!
I hope that current output could be improved even more - if Finale can
handle these things perfectly, then we should be able too :)
See "Postscript printer errors with rounded barlines" thread on devel.

> (extreme zoom, notice the round edge of the stall line on the right :) )



reply via email to

[Prev in Thread] Current Thread [Next in Thread]