[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Linphone-developers] [Q] re-invite with new RTP address and port ?

From: Aymeric Moizard
Subject: Re: [Linphone-developers] [Q] re-invite with new RTP address and port ?
Date: Thu, 7 Jul 2005 13:33:06 +0200 (CEST)

On Wed, 6 Jul 2005, Simon Morlat wrote:

Hi Clement,

You are right linphone does not support reinvite, nor in the lastest CVS.
A patch is welcome.

The only good patch for this would be to upgrade to latest libeXosip2 release.

I do not have much time for this but this would definitly provide
a lot of new features to linphone. (REFER, MESSAGE, re-INVITE...)



Le Mercredi 6 Juillet 2005 09:37, Clement Chen a écrit :
    I used Linphone 1.0.1 with the asterisk IP PBX. When I configured
linphone's extension on the PBX to allow "canreinvite", PBX will send
a re-invite message containing the call peer's IP address and RTP port
instead of PBX's after a call is established. However, I saw linphone
response "200 OK" but not reset the RTP stream to use the new IP
address and RTP port. Does the latest snapshot in the CVS repository
support this ? If not, I would try to patch linphone to provide such
    Basically, all RTP traffic in a call will go to asterisk PBX first
and then PBX will pass it. When "canreinvite=yes" is set for both
peers, the asterisk PBX will send re-invite messages to both peers
after the call is established to ask them to send RTP traffic directly
to each other without passing through the PBX.



Linphone-developers mailing list

Linphone-developers mailing list

reply via email to

[Prev in Thread] Current Thread [Next in Thread]