Hi, All --
I'm trying to get Linphone 3.5.0 running on Blackfin (BF527), but I'm running
into some
problems.
When I try to establish a call (either inbound or outbound), I get the ring or
ringback
tone, but when the call is accepted, my CPU usage spikes to 96-100% and
linphonec becomes
unresponsive. When I hang up on the remote end, the BYE message isn't always
seen by
linphone. Whether or not the BYE message is seen, linphonec continues to eat up
96-100% of
my CPU usage until I issue a kill -9 on it.
I'm still trying to narrow down where the problem is, but I'm wondering if
anyone else has
run into this or has any ideas.
Thanks.