[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
How do you create a stepped path for a @Link?
From: |
Mark Summerfield |
Subject: |
How do you create a stepped path for a @Link? |
Date: |
Fri, 30 Aug 2002 16:10:33 +0100 |
Hi,
I'm producing a diagram with lout. I need to connect two curveboxes
using a step link path so that I can avoid colliding with a curvebox
in-between:
_________
| Box A |
+-------+ _
| ^
| | AV
| v
+----------+ -
| ^
| | BV
| v
+---------------+ ___________ -
| | Box C |
____|____ +---------+
| Box B |
+-------+
|<-------->|
H
Ideally I'd like a symbol that would do this, e.g.
@SteppedLine avert { 1f } bvert { 1f } horiz { 2f }
@SteppedCurveLine
@SteppedArrow
@SteppedCurveArrow
Only three parameters are needed, AV, BV and H.
I tried following the manual but the only path example I could find just
joined two points using a straight line. I also looked at diagf but
couldn't figure it out from that either.
Thanks!
--
Mark.
[Prev in Thread] |
Current Thread |
[Next in Thread] |
- How do you create a stepped path for a @Link?,
Mark Summerfield <=