Hey I don’t know if anyone out there in
LTIB land has successfully done this or not but With all of
the approaches I have tried off the internet to get a stack
backtrace of my crashed application code on an LPC3250 CPU and
Kernel 2.6.34, nothing has worked. I have tried also using
‘catchsegv’ but the output does not make any sense. My code
has deliberate SEGV errors to induce the dump code to work but
the output is nonsensical. I find it interesting that when
running debug with the exact same code (Debug build) the GDB
utility does a fine job of showing the stack back trace just
the way I would like to see it almost but I have no idea how
it does that. Also a common problem with ARM is the back
trace count only accounts for 1 entry which is the return from
error interrupt (useless duh). Any suggestions I will repay
with kindness when I can answer one of your questions.
Chris
Westervelt
Senior
Product Development Engineer
Advantor
Systems.
12612 Challenger Pkwy
Suite 300
Orlando, FL
32826
http://www.advantor.com
Office: (407) 926-6983
Mobile:
(407) 595-7023
Fax: (407) 857-1635
Notice
of Confidentiality:
This
e-mail communication and the attachments hereto, if any, are
intended solely for the information and use of the
addressee(s) identified above and may contain information
which is legally privileged and/or otherwise confidential.
If a recipient of this e-mail communication is not an
addressee (or an authorized representative of an addressee),
such recipient is hereby advised that any review,
disclosure, reproduction, re-transmission or other
dissemination or use of this e-mail communication (or any
information contained herein) is strictly prohibited. If you
are not an addressee and have received this e-mail
communication in error, please advise the sender of that
circumstance either by reply e-mail or by telephone at (800)
238-2686, immediately delete this e-mail communication from
any computer and destroy all physical copies of same.