I haven't checked the CVS head, but in version 1.1.0, there seems to be
a problem in the processing of the listening pcb's.|
There is a loop that tries to correct these pcb's if their IP address
has changed. The problem is that there is no check to see if the
listening pcb doesn't care about the address. Normally, this will
cause no problems. It takes some pretty elaborate circumstances
(involving DHCP on two or more interfaces and listening before the DHCP
address is acquired) for this to be an issue. Nevertheless, I think it
is wrong in principal to change a pcb from listening on any IP address
to listening on a specific one.
Have I missed something?
|Gibbons and Associates, Inc.
|TEL: (408) 984-1441
|900 Lafayette, Suite 704, Santa Clara, CA
|FAX: (408) 247-6395