[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: multiple email servers with authentication

From: Gee Fitz
Subject: Re: multiple email servers with authentication
Date: Tue, 29 May 2018 22:00:49 -0300

Well. You'll have more luck doing that in postfix or whatever you use to relay email. Did you look at ssmtp?

Can't remember if it supports multiple auth or protocols.

On Tue, May 29, 2018 at 9:51 PM, <address@hidden> wrote:
I tried something similar (I moved the timeout to the one clause at the end). That didn't work. So it's not only "probably" not that syntax, it's definitely not that syntax.

And I read the docs. As you noticed, it does NOT document how to supply the auth and protocol per server, which is a very common requirement.

I should have commented that I'm currently running v5.14.

-----Original Message-----
From: Gee Fitz <address@hidden>
To: This is the general mailing list for monit <address@hidden>
Sent: Tue, 29 May 2018 8:37 PM
Subject: Re: multiple email servers with authentication

Documentation clearly says

-- Example (setting two mail servers for failover):
set mailserver,

So it's probably

set mailserver port 587, port 465

On Tue, May 29, 2018 at 5:55 PM, AJ Weber <address@hidden> wrote:
I am attempting to configure multiple (backup) mailserver's. Each has a unique username and password, and in fact, each has different ports, protocols, etc.

I have tried this:

set mailserver port 587
username address@hidden password "xxxxxxxxxx"
with timeout 30 seconds, port 465
username otheruser password "yyyyyyyyyyyyyyyyyy"
using SSL with timeout 30 seconds

This results in a configuration syntax error.

Can someone help me figure out how to configure my mailservers?



To unsubscribe:

To unsubscribe:

reply via email to

[Prev in Thread] Current Thread [Next in Thread]