[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Openvortex-dev] getting au8830 alsa to work?
From: |
Sean . |
Subject: |
[Openvortex-dev] getting au8830 alsa to work? |
Date: |
Tue, 22 Apr 2003 14:26:38 -0400 |
Hi, I have a Vortex 2 card (see bottom for info) and I'm trying to get the
0.9.2 ALSA drivers to work.
First, I tried the most recent patch, patch-au88x0-0.92e.bz2, which patched
the sources fine, but I couldn't get it to compile (using both ./configure
&& make, and also cvscompile):
make -C mpu401 modules
make[2]: Entering directory `/home/aethyr/alsa-driver-0.9.2/drivers/mpu401'
make[2]: *** No rule to make target `modules'. Stop.
make[2]: Leaving directory `/home/aethyr/alsa-driver-0.9.2/drivers/mpu401'
make[1]: *** [_modsubdir_mpu401] Error 2
make[1]: Leaving directory `/home/aethyr/alsa-driver-0.9.2/drivers'
make: *** [compile] Error 1
Then I tried patch-au88x0-0.92d.bz2, which compiled fine. I then did "make
install" and also compiled and installed alsa-lib and alsa-utils, both
version 0.9.2.
I then added the following information to my modules.conf:
# ALSA portion
alias char-major-116 snd
# OSS/Free portion
alias char-major-14 soundcore
##
## IMPORTANT:
## You need to customise this section for your specific sound card(s)
## and then run `update-modules' command.
## Read alsa-driver's INSTALL file in /usr/share/doc for more info.
##
## ALSA portion
alias snd-card-0 snd-au8830
## OSS/Free portion
alias sound-slot-0 snd-card-0
##
# OSS/Free portion - card #1
alias sound-service-0-0 snd-mixer-oss
alias sound-service-0-1 snd-seq-oss
alias sound-service-0-3 snd-pcm-oss
alias sound-service-0-8 snd-seq-oss
alias sound-service-0-12 snd-pcm-oss
alias /dev/mixer snd-mixer-oss
alias /dev/dsp snd-pcm-oss
alias /dev/midi snd-seq-oss
# Set this to the correct number of cards.
options snd cards_limit=1
And then I ran "/etc/init.d/alsasound start"
the module seemed to start up ok,
"Starting sound driver: snd-au8830 done"
lsmod returns the following:
snd-mixer-oss 13848 1 (autoclean)
snd-seq-midi 4192 0 (unused)
snd-seq-midi-event 3528 0 [snd-seq-midi]
snd-seq 40144 0 [snd-seq-midi snd-seq-midi-event]
snd-au8830 25240 1
snd-ac97-codec 38048 0 [snd-au8830]
snd-pcm 64768 0 [snd-au8830]
snd-timer 15880 0 [snd-seq snd-pcm]
snd-mpu401-uart 3824 0 [snd-au8830]
snd-rawmidi 14688 0 [snd-seq-midi snd-mpu401-uart]
snd-seq-device 4480 0 [snd-seq-midi snd-seq snd-rawmidi]
snd 32548 0 [snd-mixer-oss snd-seq-midi
snd-seq-midi-event snd-seq snd-au8830 snd-ac97-codec snd-pcm snd-timer
snd-mpu401-uart snd-rawmidi snd-seq-device]
soundcore 4228 3 [snd]
NVdriver 1067424 10 (autoclean)
snd-page-alloc 5292 0 [snd-pcm]
I then used alsamixer to turn the volume up in the Master and PCM channel to
100%
However, whenever I use aplay, or even "cat /dev/urandom > /dev/dsp" I get
no sound. No cracks, pops, whistles, beeps, nothing, just complete silence.
I've tried everything I can think of. The OSS drivers work fine, but I was
interested in trying these new ALSA drivers.
I'm using kernel-2.4.20-ck6, which can be found here:
http://kernel.kolivas.org
I tried it both with sound compiled into the kernel, and sound compiled as a
module. Neither way seems to work.
Sound card info:
00:0d.0 Multimedia audio controller: Aureal Semiconductor Vortex 2 (rev fe)
Subsystem: Diamond Multimedia Systems Monster Sound II
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort-
<MAbort- >SERR- <PERR-
Latency: 32 (1000ns min, 3000ns max), cache line size 08
Interrupt: pin A routed to IRQ 10
Region 0: Memory at d9100000 (32-bit, non-prefetchable) [size=256K]
Region 1: I/O ports at d800 [size=8]
Region 2: I/O ports at dc00 [size=8]
Capabilities: [dc] Power Management version 1
Flags: PMEClk- DSI+ D1- D2+ AuxCurrent=0mA
PME(D0-,D1-,D2-,D3hot-,D3cold-)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-
_________________________________________________________________
Tired of spam? Get advanced junk mail protection with MSN 8.
http://join.msn.com/?page=features/junkmail
- [Openvortex-dev] getting au8830 alsa to work?,
Sean . <=