[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Paparazzi-devel] Tiny v2

From: Uttam Chandrashekhar
Subject: Re: [Paparazzi-devel] Tiny v2
Date: Sat, 5 Jan 2008 19:38:17 -0800 (PST)

These are the switches available on the T6Xhs TX:

Switch A- Elevator dual rate
Switch B- Airbrake switch
Switch C- Aileron dual rates
Switch D- Elevator to Flap mixing switch
Switch E- Landing gear switch
Switch F- Trainer
Ch6 Knob- Flap/Flap trim in flaperon function

All are 2 way switches. How do I go about adding a 3 way switch to my TX, Pascal?


----- Original Message ----
From: "address@hidden" <address@hidden>
To: address@hidden
Sent: Sunday, January 6, 2008 6:17:26 AM
Subject: RE: [Paparazzi-devel] Tiny v2

I definitely suggest a switch.  If you have some sort of issue that requires taking the plane out of the current mode, turning a knob is not a good way to do so.  The last thing you want is to go to manual when you wanted auto1, or to not get out of the mode to begin with because you didnt dial in the right value.

-------- Original Message --------
Subject: Re: [Paparazzi-devel] Tiny v2
From: Pascal Brisset <address@hidden>
Date: Sat, January 05, 2008 11:28 am
To: address@hidden

Uttam Chandrashekhar wrote:
> Thanks Pascal. I have a Futaba T6Xhs programmable TX, but I don't see
> a three position switch:( It has a Flap knob on channel 6 though. What
> do I do? Can I use this TX with the paparazzi?
No cursor available ?
It is usually easy to add a 3 position switch to a transmitter, using
resistor bridges ... and a scope to produce the appropriate signal.


Paparazzi-devel mailing list

Be a better friend, newshound, and know-it-all with Yahoo! Mobile. Try it now.
reply via email to

[Prev in Thread] Current Thread [Next in Thread]