[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Paparazzi-devel] IR2 ADC problem

From: Alston Pike
Subject: Re: [Paparazzi-devel] IR2 ADC problem
Date: Mon, 23 Mar 2009 11:58:00 -0500

Maybe this will get you pointed in the right direction...

Alston Pike
BSME 2009
The University of Alabama
(706) 594-2812

2009/3/23 denis bourras <address@hidden>
Dear all,
I am trying to set up the tiny2_1_1 for use in a glow powered aircraft
So far, the GPS tunnel is working, the GCS is populating, the xbee modems are working, the receiver ppm signal is ok, and the connected servos receive a correct pulse signal.
My next issue concerns the IR sensors. Vertical and IR1 react normally when I move them (port1,6 and port1,7 if I am not wrong), but ir2 (port 0,4) does not : it gives a constant -512 (all the neutral values were set to 512). Does anyone have the same problem ?
----- Original Message -----
From: Stephen L Hulme
To: address@hidden
Sent: Monday, March 23, 2009 11:45 AM
Subject: [Paparazzi-devel] Funjet1.xml testing IR H & Top with gyro.

Hi there, once again.
Does one calibrate and tune the two IR sensor arrays simultaneously with the gyro engaged and powered up or not.? 
Thanks in advance

Paparazzi-devel mailing list

Paparazzi-devel mailing list

reply via email to

[Prev in Thread] Current Thread [Next in Thread]