[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: RE: [Paparazzi-devel] First power-up of Autopilot OK, some questions

From: Martin P
Subject: Re: RE: [Paparazzi-devel] First power-up of Autopilot OK, some questions
Date: Wed, 13 May 2009 21:36:33 +0200

Thanks, Cédric and sorry for the RTFM question. 

About the coordinator/end-device thing, I found out that this is not necessary 
for the XBEE Pro 868. Using the X-CTU I was able to do a loop test by 
shortening DO and DI on the remote modem. Then I connected teh modem to the 

Did I connect the modem correctly?  
TxD (blue)  to DI (pin 3 on the Xbee)
RxD (green) to DO (pin 2 on the Xbee)

For the time being, I stayed with a baudrate of 9600 and added a corresponding 
section in the control_panel.xml. 
In the Paarazzi center or GCS, how do I see if there is a connection? 

On the first try, the GCS worked and the GPS section showed various signal 
strength bars grey or red, but did not get a fix. 

I stopped the Paparazzi center and started again, but now the GCS does not show 
anything. The main section is all black and the lower section of the window is 
just white without showing the strips and flightplan/PFD/GPS or anything else. 

Greetz, Martin 

-------- Original-Nachricht --------
> Datum: Wed, 13 May 2009 08:04:53 +0200
> Von: "Cédric Marzer" <address@hidden>
> An: address@hidden
> Betreff: RE: [Paparazzi-devel] First power-up of Autopilot OK, some questions

> Have a look at the wiki :
> chapter "Setting access right for USB download"
> Cédric
> >Compilng the airborne software was OK, but loading worked only when I
> started paparazzi as root. Otherwise I >was not allowed to access the USB. 
> _______________________________________________
> Paparazzi-devel mailing list
> address@hidden

reply via email to

[Prev in Thread] Current Thread [Next in Thread]