[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Paparazzi-devel] 3 state switch on any R/C controller

From: Andrew S
Subject: Re: [Paparazzi-devel] 3 state switch on any R/C controller
Date: Sat, 30 May 2009 21:08:07 +0400

try to add two resistor divider between switch inputs. this would give central 

30.05.09, 17:04, "? flying pig" <address@hidden>:

> Hi there
>   I have recently got one of the remote controll from someone, it is 4 
> channel 40Mhz, the brand is REELY (from Conrad in Germany i believe). I was 
> thinking using for paparazzi.
>   I have tap in to the R/C receiver, which was ok (just read the chip number 
> without any measurement), however, I have some didfficulty in making 3 state 
> switch.
>   I cut the yaw channel (4th channel), and rewire to 3 state switch 
> (on/off/on), however, when i use it, it seen like only have on/off function.
>   Does anyone has done the similar thing about cutting one channel from the 
> controller to make it into the 3 state switch?  can anyone advice?
> Regards
>                        Chen
> 5 GB ???? ????????????????? — ???? Windows Live Hotmail 
Есть ли письма? Знает мобильная Яндекс.Почта 

reply via email to

[Prev in Thread] Current Thread [Next in Thread]