[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Paparazzi-devel] EagleTree Airspeed Sensor codes

From: Martin Mueller
Subject: Re: [Paparazzi-devel] EagleTree Airspeed Sensor codes
Date: Fri, 05 Nov 2010 16:56:52 +0100
User-agent: Mozilla/5.0 (X11; U; Linux i686; en-US; rv: Gecko/20101027 Thunderbird/3.0.10

Then please post the error message :-)

On 05.11.2010 16:54, Felix Ruess wrote:
You actually should get an error message telling you to change it to
twog_1.0 if you still have twog_1 set as your board.

On Fri, Nov 5, 2010 at 4:52 PM, Martin Mueller<address@hidden>  wrote:

try twog_1.0 instead of twog_1

On 05.11.2010 16:41, Roman Nikitin wrote:

Hi all,

I used the instructions on wiki to add the codes for EagleTree Airspeed
Sensor. Before I did it, my simulation was running unobstructed. After I
did add the codes I have a number of errors.

As I did error check, I realised that most of the .xml documents do not
exist anymore.

Please could anybody check the instructions on the wiki, if they are
up-to-date. And it would be quite useful to have an example code so that
I can compare my and working codes.

I am using Twog1.

Thank you.



Bristol Institute of Technology

University of the West of England

Aerospace Systems Engineering

email: address@hidden<mailto:address@hidden>

Mob.: +44 (0) 7760806643

*P** **please consider the environment before printing emails.** *

Paparazzi-devel mailing list

Paparazzi-devel mailing list

Paparazzi-devel mailing list

reply via email to

[Prev in Thread] Current Thread [Next in Thread]