[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: [Paparazzi-devel] Powering the ArduIMU+ V2 with 3.3V

From: mark.griffin
Subject: RE: [Paparazzi-devel] Powering the ArduIMU+ V2 with 3.3V
Date: Wed, 10 Nov 2010 11:22:02 +0100

Hi Oli,

You cannot power it through the 3.3V i2c connector. In fact, leave this pin unconnected.

You can power it with 5.0 volts on the VCC/5V pin or >6 volts on the VIN pin.

Cheers, mark


From: address@hidden [mailto:address@hidden On Behalf Of Ensslin Oliver (enso)
Sent: Wednesday, 10 November 2010 11:01 AM
To: address@hidden
Subject: [Paparazzi-devel] Powering the ArduIMU+ V2 with 3.3V


Hi all


I do not know how to power the ArduIMU+ V2.


Can I power it through the 3.3 V of the I2C connector or do I have to take the 5V on the other side of the board (the one in X direction)?


Your suggestions will be appreciated.





reply via email to

[Prev in Thread] Current Thread [Next in Thread]