Hi Christophe
I noted while I was away you made some significant
changes to the ~/conf/modules/digital_cam.xml files.
I am not a software expert and would like to know
if I can still use my pentax remote controller as depicted in the attached
picture (originally supplied by Pascal Brisset).
The original digital_cam.xml file I was using
is as follows:
<!DOCTYPE
module SYSTEM "./module.dtd">
<module
name="digital_cam">
<header>
<file
name="dc.h"/>
</header>
<init
fun="dc_init()"/>
<periodic fun="dc_periodic()" freq="4"
autorun="TRUE"/>
<makefile>
<raw>
# ap.CFLAGS += -DGPS_TRIGGERED_FUNCTION="dc_shoot_on_gps"
# ap.CFLAGS += -DDC_GPS_TRIGGER_START=1
# ap.CFLAGS +=
-DDC_GPS_TRIGGER_STOP=3
</raw>
<flag name="DIGITAL_CAM"
/>
<file name="dc.c"/>
</makefile>
</module>
together with this airframe xml description:
<section
name="Digital camera telecommand">
<!-- IOs are seen
as LEDs -->
<define name="LED_6_BANK"
value="0"/>
<define name="LED_6_PIN" value="2"/>
<!-- I2C SCL -->
<!-- ADC 5
-->
<define name="LED_7_BANK"
value="0"/>
<define name="LED_7_PIN" value="3"/>
<!-- I2C SDA -->
<define
name="DC_SHUTTER_LED" value="6"/> <!-- Grey wire
-->
<define name="DC_ZOOM_LED"
value="7"/>
</section>
plus the associated hardware conf and settings
file.
Any help appreciated.
Regards
Stephen