[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Paparazzi-devel] re:xbee pro xsc 900

From: David Conger
Subject: Re: [Paparazzi-devel] re:xbee pro xsc 900
Date: Thu, 13 Jan 2011 19:28:06 -0800


I don't use any boards. I power the modem from the 3.3v on the serial connector and the XBEe ends are soldered directly to the top of the XBee. At the groundstation side I'm using my FTDI Utility with an XBee socket. I always program the XSC for 57600bps and they work on my Booz quad, Merlin fixed wing, FunJet fixed wing. 
I use the "transparent" protocol. 

On Jan 12, 2011, at 11:52 PM, GARCIA ALVAREZ, ANA wrote:

Hi again,
I have changed the baud rate to 57600. Now the gcs populates(with waypoints and status). I have downlink but not datalink (I mean, from gcs to autopilot).
I had the same problem with the xbee pro 2.4ghz but it ran when I set the destination address low to FFFF in the gcs module.
I wonder if there is any special parameter with these xsc 900 which I should take care.
David, do you use the sparkfun boards or any others? I am now just thinking it could be related to the gcs board(where I have not removed a diode, provided that I had to remove one in the on-air board). Does it make sense? Do you use the transparent protocol?
Paparazzi-devel mailing list

reply via email to

[Prev in Thread] Current Thread [Next in Thread]