Bruzzlee, i am using lisa/m too.
I have strange behavior with my copter.
Some of this caused by vibration and other that i not know the
> From: address@hidden
> Date: Sun, 1 Jan 2012 01:46:19 +1030
> To: address@hidden
> Subject: Re: [Paparazzi-devel] Lisa M wiring layout
> Hi Bruzzlee
> It looks good to me and yes the ADC1 bridge is needed
only for the initial bind to the Spektrum receiver (or
receivers, you can use two at once)
> On 30/12/2011, at 7:51 AM, Bruzzlee wrote:
> > Hi all
> > After a long break I've continued the work on my
quadrotor Lisa M project. Now I've done my wiring layout but
I'm not sure if everything is correct.
> > Especially the power source for the board: I2C1 CAN
(V_BATT/GND) or SERVO1 (SV/GND)?
> > The ADC1 bridge - I need it only for the first
binding to the spectrum remote - right?
> > I want to publish this layout on wiki - please
> > thx
> > Bruzzlee
> > Paparazzi-devel mailing list
> > address@hidden
> Paparazzi-devel mailing list