paparazzi-devel
[Top][All Lists]
Advanced

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Paparazzi-devel] On board data logging using TWOG


From: Eduardo lavratti
Subject: Re: [Paparazzi-devel] On board data logging using TWOG
Date: Sun, 6 May 2012 02:28:05 +0000

Cedric, i have the same problem when i installed my logger.

I am not sure, but i think i run first the openlog2tlm and after i run sd2log.

Try it.


> From: address@hidden
> Date: Sat, 5 May 2012 20:01:28 +0200
> To: address@hidden
> Subject: Re: [Paparazzi-devel] On board data logging using TWOG
>
> Hello Martin,
> I succeeded to make the logomatic log thanks to your code, but when I try to use sd2log I get the following error : pprz.values_of_payload too many bytes…
> I must admit that I haven't soldered the capacitor you mentioned. I might try that tonight but I doubt that it is the problem…
> Did you make a change to the code that is not reflected to the github ?
> I also noticed that the logomatic code is only in the dev branch (and this is not mentioned in the wiki).
> Thank you for your help.
> Cédric
>
>
> Le 11 mars 2012 à 15:25, Martin Mueller a écrit :
>
> > Hi Cédric,
> >
> > have added support for the Logomatic on the dev branch. Some general fixes for the logger were also needed.
> >
> > Had not seen that Sparkfun board. Looks interesting, maybe a little too huge (only a few millimeters shorter than the Tiny). Had to add at least a large capacitor to the LiPo port to make it work. Otherwise the charge circuit kept the Vcc oscillating too much.
> >
> > Needs some changed routing to make use of the LiPo together with an autopilot (USB Vbus <-> 5V from autopilot).
> >
> > Martin
>
>
> _______________________________________________
> Paparazzi-devel mailing list
> address@hidden
> https://lists.nongnu.org/mailman/listinfo/paparazzi-devel

reply via email to

[Prev in Thread] Current Thread [Next in Thread]