[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[Paparazzi-devel] lisa adc problem

From: Chris
Subject: [Paparazzi-devel] lisa adc problem
Date: Mon, 08 Oct 2012 21:59:10 +0300
User-agent: Mozilla/5.0 (X11; Linux i686; rv:15.0) Gecko/20120912 Thunderbird/15.0.1

Now that i have setup almost everything a new kind of problem appeared.
I am using ADC3 for current measurements and the channel is working fine but it needs a 2-3 Kohm pull down resistor because otherwise it floats at 1.168v. The only change i made was to move the ppm input from servo 6 to UART1 Rx, i will try the original
code tomorrow.
I am sure that it worked fine before and the board is clean.
Any ideas?

reply via email to

[Prev in Thread] Current Thread [Next in Thread]