paparazzi-devel
[Top][All Lists]
Advanced

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Paparazzi-devel] Errors on updated version


From: Felix Ruess
Subject: Re: [Paparazzi-devel] Errors on updated version
Date: Tue, 15 Jan 2013 14:49:03 +0100

Hi Arni,

the tiny_2.11 does not have the SYS_TIME_LED enabled by default: http://paparazzi.enac.fr/wiki/Tiny/v2.11#LEDs
You can configure that: http://paparazzi.enac.fr/wiki/Airframe_Configuration#LEDs
At least the SYS_TIME_LED should blink with 1Hz when you have it enabled.

I don't have your hardware config, so I can't test this.
Could you try to disable/comment out all the optional modules and try again.
And maybe try to remove the imu ppzuav subsystem (leave the infrared module and change the ahrs to infrared).

Cheers, Felix


On Tue, Jan 15, 2013 at 2:28 PM, Árni Þorvaldsson <address@hidden> wrote:
Hi and thanks for the reply
I am not getting any errors now but the problem is that I am not receiving any data  from the Tiny.

Here is the firmware section:

<!DOCTYPE airframe SYSTEM "airframe.dtd">

<!-- Funjet Multiplex (http://www.multiplex-rc.de/)
     Tiny 2.11 board (http://paparazzi.enac.fr/wiki/Tiny_v2.11)
     XBee modem with AT firmware
     LEA 5H GPS
-->

<airframe name="Funjet Tiny 2.11">

  <firmware name="fixedwing">
    <define name="AGR_CLIMB"/>
    <define name="USE_AIRSPEED"/>
    <define name="SENSOR_SYNC_SEND"/>
    <define name="USE_BARO_MS5611"/>
    <define name="LOITER_TRIM"/>
    <define name="ALT_KALMAN"/>

    <target name="sim"             board="pc"/>

    <target name="ap"             board="tiny_2.11">
    </target>

    <subsystem name="radio_control" type="ppm"/>
    <subsystem name="joystick"/>

    <!-- Communication -->
    <subsystem name="telemetry" type="transparent"/>
    <subsystem name="imu" type="ppzuav"/>


    <!-- Actuators are automatically chosen according to board-->
    <subsystem name="control"/>
    <!-- Sensors -->
    <subsystem name="ahrs"     type="float_dcm"/>
    <subsystem name="gps"      type="ublox"/>
    <subsystem name="ins"      type="alt_float"/>
    <subsystem name="navigation"/>


  </firmware>

  <modules>
    <load name="infrared_adc.xml"/>
    <load name="humid_sht.xml"/>
    <load name="airspeed_ets.xml"/>
    <load name="temp_temod.xml"/>
    <load name="baro_ms5611_i2c.xml"/>
  </modules>

  <firmware name="setup">
    <target name="tunnel"             board="tiny_2.11"/>
    <target name="setup_actuators"     board="tiny_2.11"/>
  </firmware>


Regards Arni
________________________________
Frá: paparazzi-devel-bounces+arnitho10=address@hidden [paparazzi-devel-bounces+arnitho10=address@hidden] fyrir hönd Felix Ruess [address@hidden]
Sent: 14. janúar 2013 12:57
To: Paparazzi devel list
Efni: Re: [Paparazzi-devel] Errors on updated version

Hi Arni,

Could you please post at least the firmware section so we know what architecture/board/firmware/subsystems you are using?
Most boards have some leds enabled by default (e.g. the SYS_TIME_LED that should blink with 1Hz).

Regarding the conf.xml: as the message says you can either update the outdated config or remove them if you don't want/need these other airframes.
You could also copy conf.xml.example and then just add your ariframe again to get up-to-date examples.

Cheers, Felix


On Mon, Jan 14, 2013 at 12:38 PM, Árni Þorvaldsson <address@hidden<mailto:address@hidden>> wrote:
Thanks Felix that worked for me and it builds.
I upload without errors the leds are not blinking after the upload. ( is that okay?)

Current size:
/home/notandi/paparazzi/var/Belgingur/ap/ap.elf  :
section             size         addr
.text             145740        16384
.data              14236   1073741824
.bss                5700   1073756064
.stack              4096   1073761792
.comment              60            0
.ARM.attributes       46            0
.debug_aranges      2336            0
.debug_info        35314            0
.debug_abbrev      13041            0
.debug_line        26893            0
.debug_frame        2668            0
.debug_str          7217            0
.debug_loc         26048            0
.debug_ranges        824            0
Total             284219


make[1]: Leaving directory `/home/notandi/paparazzi/sw/airborne'
cd sw/airborne; make TARGET=ap upload
make[1]: Entering directory `/home/notandi/paparazzi/sw/airborne'
/home/notandi/paparazzi/sw/ground_segment/lpc21iap/lpc21iap  /home/notandi/paparazzi/var/Belgingur/ap/ap.elf
lpc21iap v1.3
.
Found USB device
BootROM code: 2.12
Part ID: 0x0402FF25 (LPC2148, 512k Flash, 32k+8k RAM)
BootLoader version: 1.3
#########################################
Starting software at 0x00004000
make[1]: Leaving directory `/home/notandi/paparazzi/sw/airborne'
make: Leaving directory `/home/notandi/paparazzi'

DONE (exec make -C /home/notandi/paparazzi -f Makefile.ac AIRCRAFT=Belgingur ap.upload  2>&1)


when I excecute session I get some errors. Is it okay to just erase from conf.xml?
I am not getting messages from the autopilot so it is not working right.

Run '/home/notandi/paparazzi/sw/ground_segment/tmtc/link  -d /dev/ttyUSB0 -s 57600'
Run '/home/notandi/paparazzi/sw/ground_segment/tmtc/server '
Run '/home/notandi/paparazzi/sw/ground_segment/cockpit/gcs '
A failure occurred while processing aircraft 'BOOZ2_A1'
 - Fail with : File not found: /home/notandi/paparazzi/conf/settings/settings_booz2.xml
 - 'BOOZ2_A1' will be ignored by the server
 - Please remove it from 'conf.xml' or fix its parameter(s)
A failure occurred while processing aircraft 'BOOZ2_A7'
 - Fail with : File not found: /home/notandi/paparazzi/conf/settings/settings_booz2.xml
 - 'BOOZ2_A7' will be ignored by the server
 - Please remove it from 'conf.xml' or fix its parameter(s)
A failure occurred while processing aircraft 'BOOZ2_A8'
 - Fail with : File not found: /home/notandi/paparazzi/conf/settings/settings_test_passthrough.xml
 - 'BOOZ2_A8' will be ignored by the server
 - Please remove it from 'conf.xml' or fix its parameter(s)
A failure occurred while processing aircraft 'EasyStar_ETS'
 - Fail with : File not found: /home/notandi/paparazzi/conf/settings/tuning.xml
 - 'EasyStar_ETS' will be ignored by the server
 - Please remove it from 'conf.xml' or fix its parameter(s)
A failure occurred while processing aircraft 'Hexa_LisaL'
 - Fail with : File not found: /home/notandi/paparazzi/conf/settings/settings_booz2.xml
 - 'Hexa_LisaL' will be ignored by the server
 - Please remove it from 'conf.xml' or fix its parameter(s)
A failure occurred while processing aircraft 'LISA_ASCTEC_PIOTR'
 - Fail with : File not found: /home/notandi/paparazzi/conf/settings/settings_booz2.xml
 - 'LISA_ASCTEC_PIOTR' will be ignored by the server
 - Please remove it from 'conf.xml' or fix its parameter(s)
A failure occurred while processing aircraft 'LisaM_Heli'
 - Fail with : File not found: /home/notandi/paparazzi/conf/settings/settings_booz2_ahrs_cmpl.xml
 - 'LisaM_Heli' will be ignored by the server
 - Please remove it from 'conf.xml' or fix its parameter(s)
A failure occurred while processing aircraft 'Microjet'
 - Fail with : File not found: /home/notandi/paparazzi/conf/settings/basic_infrared.xml
 - 'Microjet' will be ignored by the server
 - Please remove it from 'conf.xml' or fix its parameter(s)
A failure occurred while processing aircraft 'Tiny_IMU'
 - Fail with : File not found: /home/notandi/paparazzi/conf/settings/tuning_ins.xml
 - 'Tiny_IMU' will be ignored by the server
 - Please remove it from 'conf.xml' or fix its parameter(s)
A failure occurred while processing aircraft 'Twinjet'
 - Fail with : File not found: /home/notandi/paparazzi/conf/settings/tuning.xml
 - 'Twinjet' will be ignored by the server
 - Please remove it from 'conf.xml' or fix its parameter(s)
Broadcasting on network 127.255.255.255, port 2010

DONE (exec /home/notandi/paparazzi/sw/ground_segment/cockpit/gcs  2>&1)

Best regards Arni

________________________________
Frá: paparazzi-devel-bounces+arnitho10=address@hidden<mailto:address@hidden> [paparazzi-devel-bounces+arnitho10=address@hidden<mailto:address@hidden>] fyrir hönd Felix Ruess [address@hidden<mailto:address@hidden>]
Sent: 14. janúar 2013 11:10
To: Paparazzi devel list
Efni: Re: [Paparazzi-devel] Errors on updated version

Hi Arni,

in the development branch the ins subsystem is mandatory.
To use altitude filtering add
<subsystem name="ins" type="alt_float"/>
or to just use a "fake" ins that passes gps values along as is:
<subsystem name="ins" type="gps_passthrough"/>

Cheers, Felix


On Mon, Jan 14, 2013 at 11:27 AM, Árni Þorvaldsson <address@hidden<mailto:address@hidden><mailto:address@hidden<mailto:address@hidden>>> wrote:
Hi ,
I just updated my paparazzi to v4.9_devel-377-gba37ac6
but got a lot of errors while building my files.

CC /home/notandi/paparazzi/var/Belgingur/ap/modules/sensors/baro_ms5611_i2c.o
LD /home/notandi/paparazzi/var/Belgingur/ap/ap.elf
/home/notandi/paparazzi/var/Belgingur/ap/firmwares/fixedwing/main_ap.o: In function `init_ap':
main_ap.c:(.text.init_ap+0x18): undefined reference to `ins_init'
/home/notandi/paparazzi/var/Belgingur/ap/firmwares/fixedwing/main_ap.o: In function `sensors_task':
main_ap.c:(.text.sensors_task+0x24): undefined reference to `ins_periodic'
/home/notandi/paparazzi/var/Belgingur/ap/firmwares/fixedwing/main_ap.o: In function `event_task_ap':
main_ap.c:(.text.event_task_ap+0x2cc): undefined reference to `ins_update_gps'
collect2: ld returned 1 exit status
make[1]: *** [/home/notandi/paparazzi/var/Belgingur/ap/ap.elf] Error 1
make[1]: Leaving directory `/home/notandi/paparazzi/sw/airborne'
make: *** [ap.compile] Error 2
make: Leaving directory `/home/notandi/paparazzi'


regards Arni





_______________________________________________
Paparazzi-devel mailing list
address@hidden<mailto:address@hidden><mailto:address@hidden<mailto:address@hidden>>
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel


_______________________________________________
Paparazzi-devel mailing list
address@hidden<mailto:address@hidden>
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel


_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel


reply via email to

[Prev in Thread] Current Thread [Next in Thread]