[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Paparazzi-devel] Powering Lisa/M 2.0

From: Balazs GATI
Subject: Re: [Paparazzi-devel] Powering Lisa/M 2.0
Date: Mon, 05 May 2014 16:27:18 +0200
User-agent: Mozilla/5.0 (Windows NT 6.1; WOW64; rv:24.0) Gecko/20100101 Thunderbird/24.4.0

Perhaps you can power both rail with the same BEC.


2014.05.04. 1:28 keltezéssel, Dylan Brunello írta:
Thanks Piotr and Chris.

On Sunday, 4 May 2014, Chris <address@hidden
<mailto:address@hidden>> wrote:

    No problem at all if you don't parallel the output of 2 or more BECs.
    Sometimes linear BECs (switchmode never) can be paralleled but this
    is not a good practice in any case.
    In other words if you use more than one BEC in a split load
    configuration but make sure that their + rail is not paralleled.

    On 05/03/2014 01:59 PM, Dylan Brunello wrote:

    I have a Lisa/M 2.0 configured with the default power jumpers. I'd
    like to power everything in the system from a single battery (3S
    LiPo). The plan is to power the servo rail using the 5V BEC on the
    ESC. Is it safe to connect an additional 5V BEC to the battery and
    use that to power the Lisa and peripherals? My concern is the two
    BECs on the one battery. Any thoughts regarding powering the
    system in this fashion?


    Paparazzi-devel mailing list
    address@hidden  <javascript:_e(%7B%7D,'cvml','address@hidden');>

Paparazzi-devel mailing list

Balazs GATI, PhD
associate professor
     Department of Aeronautics, Naval Architecture and Railway Vehicles
     Budapest University of Technology and Economics

Address:   Budapest
          Stoczek u 6. J. ép. 423
Tel:       +(36)-1-463-1960
Fax:       +(36)-1-463-3080

reply via email to

[Prev in Thread] Current Thread [Next in Thread]