[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Paparazzi-devel] Using 2 RC receivers on board

From: Chris
Subject: Re: [Paparazzi-devel] Using 2 RC receivers on board
Date: Fri, 09 May 2014 11:15:30 +0300
User-agent: Mozilla/5.0 (X11; Linux i686; rv:24.0) Gecko/20100101 Thunderbird/24.5.0

It does not replace two receivers, what i meant was that the system is so good and robust that i doubt
you going to need two receivers.
Two receivers are better but the whole system has other much more critical points that can fail.
How ever if you insist you can use two receivers with this contraption
and a spare receiver even on a different band.
I have used it and it works fine.

On 05/09/2014 12:08 AM, GalapagosUAV wrote:
Hello Chris,

Thank you for your reply. How does the Frsky ACCST system would help or replace 
a system with 2 receivers? I looked at their webpage but there is not much more 

I am currently using Futaba T8J 2.4GHz S-FHSS. I haven't had problems with my 
RC radios, however I would to be able to override the autopilot (I am using a 
YAPA2) in case of failure.

Best Regards,

On 08/05/2014, at 15:16, Chris <address@hidden> wrote:

You don't need two, use the Frsky ACCST system (actually developed by ACT 
Germany) and fly happily
without problems.
If you insist i think paparazzi autopilots can use two spectrum receivers which 
personally i don't trust at all.
Have a look in the wiki under Hardware -> autopilots

On 05/08/2014 07:55 PM, GalapagosUAV wrote:
Dear all,

I would like to know if anyone has ever used 2 RC receivers on board for 
redundancy purposes? If yes, how can I do this? What I would like to do is 
while having one receiver connected to the autopilot via de PPM encoder, have 
another one that is not connected to autopilot but goes directly to the servos 
in case of autopilot failure.

Best Regards,
Paparazzi-devel mailing list

Paparazzi-devel mailing list
Paparazzi-devel mailing list

reply via email to

[Prev in Thread] Current Thread [Next in Thread]