[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Paparazzi-devel] Powering Lisa/M

From: alonso acuña
Subject: Re: [Paparazzi-devel] Powering Lisa/M
Date: Tue, 27 May 2014 17:27:48 -0600

What I do is use 4s bateries but I take a cable from the balancing conector on the batery. I take the one that normally has around 12v and this is what I connect to V_BAT.  If you keep your cells balanced then measuring the voltage on 3 of them is fine and make sure to adjust the voltage values in the airframe file to match.

On Thu, May 22, 2014 at 7:02 AM, Marius Pfeffer <address@hidden> wrote:


If you use a battery with more than 3 cells the voltage divider has the wrong resistor values. (if you connect a battery with more cells direct you would go over the maximum voltage of that pin)

Take a look at the Lisa/m wiki page.

You need to change the resistors of the voltage divider.


Am 22.05.2014 14:58 schrieb "Joey" <address@hidden>:

Hi all,

I read that I cannot use a battery with more than 3 cells if I want to
measure the voltage with the V_BAT pin on the I2C. However, the motors that
I want to use need a battery with more than 3 cells. Is there a way to
connect a battery with more than 3 cells?



View this message in context:
Sent from the paparazzi-devel mailing list archive at

Paparazzi-devel mailing list

Paparazzi-devel mailing list

reply via email to

[Prev in Thread] Current Thread [Next in Thread]