|Subject:||Re: [Paparazzi-devel] px4fmu|
|Date:||Sun, 7 Jun 2015 15:12:06 +0200|
Hector Garcia de Marina writes:
> Hi Oswald,
> I have never used ppz in px4. But I guess that the guys from px4 are not
> using the same bootloader as in ppz (i am not sure about this).
> In any case if you flash the chip via JTAG with the ppz firmware, you
> should be able to use the bootloader for the following flashes.
hi hector, thanks for the reply.
i have tried flashing with the BMP but i seem to have a problem
there. gdb says
Target Voltage: 0.8V
JTAG device scan failed.
the board is powered from USB which i think should be fine. need to
check what is going on there.
> On May 20, 2015 12:48 PM, "Oswald Berthold" <address@hidden> wrote:
>> dear all,
>> i have a px4fmu v1.6 lying around, which i would like to use it with
>> ppz. i built the ap but i haven't managed to flash it yet. is there a
>> preferred method? is anybody using a px4 with ppz at all?
>> bst, oswald
>> Paparazzi-devel mailing list
> Paparazzi-devel mailing list
Paparazzi-devel mailing list
|[Prev in Thread]||Current Thread||[Next in Thread]|