Re: [Paparazzi-devel] No telemetry

[Evgeni Todorov]

In XCTU I can "Discover radio nodes in the same network" and the 'Flyer' (i.e. the NI of my S1) is visible. The result is absolutely equivalent to what I see when I connect the S1 to another laptop and use the XCTU console to successfully receive and transmit messages.
By 'when the board is powered' I mean when a usb is plugged in and the green LED is steadily alight.

---- On Thu, 23 Jul 2015 13:33:40 -0700 Sergey Krukowski <address@hidden> wrote ----

Hi Evgeni!

What do you actually mean under "when the board is powered I start XCTU
and can detect the S1"?
Do you see the data flow in the xctu terminal?


> Hi all,
>
> I can't get my Lisa/Mv2.0 to communicate with the GCS installed on
> Ubuntu 14.04.
>
> My configuration:
> LisaM with Aspirin 2.2 from 1 bit 2, connected via a DRX R615X receiver
> to a DX4e transmitter @ UART2, and via a Xbee Pro S1 and an Xbee Pro
> 802.15.4 usb adapter to my laptop.
>
> What I tried:
> 1. Checked the connection between the Lisa and the Xbee. UART2: Rx -&gt;
> DOUT; Tx -&gt; DIN; +3V3 -&gt; VCC; GND -&gt; GND;
> 2. Checked the configuration of the Xbee-s. Baudrates=57600 and PAN IDs
> are set, communication was fine between two laptops with XCTU. Also,
> when the board is powered I start XCTU and can detect the S1.
> 3. Checked the configuration of the airframe file:
> &lt;!-- Communication --&gt;
> &lt;subsystem name="telemetry" type="transparent"&gt;
> &lt;configure name="MODEM_BAUD" value="B57600"/&gt;
> &lt;configure name="MODEM_PORT" value="UART2"/&gt;
> &lt;/subsystem&gt;
>
> I get no errors when running the Data link program (-d /dev/ttyUSB0 -s
> 57600) or the gcs. I do get a 'Fatal error: exception
> Xml.File_not_found("~/./paparazzi/conf/modules/nav_survey_rectangle_rotorcraft.xml")'
> when I run the Server though.
>
> Other (probably un)related problems:
> - The BATT/BIND port of the R615X is connected to UART1 and the
> bind procedure from
> https://wiki.paparazziuav.org/wiki/Lisa/M_v2.0#Binding. The transmitter
> and receiver are binded (the LED turns on when I power up the receiver)
> but the servos connected don't move. I suspect the reason might be in
> settings, but can't verify because no telemetry.
> - When I try to browse for a different file I get the following
> error: Selected file '~/paparazzi/conf/airframes/...' should be in
> ~/./paparazzi/conf/airframes/...'. I did set the ENV variables to my ppz
> folder. There is a workaround, but I guess it might be related to the
> Server error.
>
> I am open to any suggestions, since I've checked multiple times
> everywhere I could think to check.
>
> Thanks!

_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel