qemu-arm
[Top][All Lists]
Advanced

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[Qemu-arm] [PATCH for-3.0 2/2] hw/intc/arm_gic: Fix handling of GICD_ITA


From: Peter Maydell
Subject: [Qemu-arm] [PATCH for-3.0 2/2] hw/intc/arm_gic: Fix handling of GICD_ITARGETSR
Date: Thu, 12 Jul 2018 16:41:52 +0100

The GICD_ITARGETSR implementation still has some 11MPCore behaviour
that we were incorrectly using in our GICv1 and GICv2 implementations
for the case where the interrupt number is less than GIC_INTERNAL.
The desired behaviour here is:
 * for 11MPCore: RAZ/WI for irqs 0..28; read a number matching the
   CPU doing the read for irqs 29..31
 * for GICv1 and v2: RAZ/WI if uniprocessor; otherwise read a
   number matching the CPU doing the read for all irqs < 32

Stop squashing GICD_ITARGETSR to 0 for IRQs 0..28 unless this
is an 11MPCore GIC.

Reported-by: Jan Kiszka <address@hidden>
Signed-off-by: Peter Maydell <address@hidden>
---
 hw/intc/arm_gic.c | 6 ++++--
 1 file changed, 4 insertions(+), 2 deletions(-)

diff --git a/hw/intc/arm_gic.c b/hw/intc/arm_gic.c
index b0a69d6386e..34dc84ae813 100644
--- a/hw/intc/arm_gic.c
+++ b/hw/intc/arm_gic.c
@@ -751,7 +751,9 @@ static uint32_t gic_dist_readb(void *opaque, hwaddr offset, 
MemTxAttrs attrs)
             if (irq >= s->num_irq) {
                 goto bad_reg;
             }
-            if (irq >= 29 && irq <= 31) {
+            if (irq < 29 && s->revision == REV_11MPCORE) {
+                res = 0;
+            } else if (irq < GIC_INTERNAL) {
                 res = cm;
             } else {
                 res = GIC_TARGET(irq);
@@ -1014,7 +1016,7 @@ static void gic_dist_writeb(void *opaque, hwaddr offset,
             if (irq >= s->num_irq) {
                 goto bad_reg;
             }
-            if (irq < 29) {
+            if (irq < 29 && s->revision == REV_11MPCORE) {
                 value = 0;
             } else if (irq < GIC_INTERNAL) {
                 value = ALL_CPU_MASK;
-- 
2.17.1




reply via email to

[Prev in Thread] Current Thread [Next in Thread]