[Qemu-arm] [PATCH v5 2/4] target/arm: Fill in ARMISARegisters for kvm64

[Richard Henderson]

Signed-off-by: Richard Henderson <address@hidden>
---
 target/arm/kvm64.c | 90 ++++++++++++++++++++++++++++++++++++++++++++--
 1 file changed, 88 insertions(+), 2 deletions(-)

diff --git a/target/arm/kvm64.c b/target/arm/kvm64.c
index 46fbe6d8ff..0a502091e7 100644
--- a/target/arm/kvm64.c
+++ b/target/arm/kvm64.c
@@ -456,17 +456,40 @@ static inline void unset_feature(uint64_t *features, int 
feature)
     *features &= ~(1ULL << feature);
 }
 
+static int read_sys_reg32(int fd, uint32_t *pret, uint64_t id)
+{
+    uint64_t ret;
+    struct kvm_one_reg idreg = { .id = id, .addr = (uintptr_t)&ret };
+    int err;
+
+    assert((id & KVM_REG_SIZE_MASK) == KVM_REG_SIZE_U64);
+    err = ioctl(fd, KVM_GET_ONE_REG, &idreg);
+    if (err < 0) {
+        return -1;
+    }
+    *pret = ret;
+    return 0;
+}
+
+static int read_sys_reg64(int fd, uint64_t *pret, uint64_t id)
+{
+    struct kvm_one_reg idreg = { .id = id, .addr = (uintptr_t)pret };
+
+    assert((id & KVM_REG_SIZE_MASK) == KVM_REG_SIZE_U64);
+    return ioctl(fd, KVM_GET_ONE_REG, &idreg);
+}
+
 bool kvm_arm_get_host_cpu_features(ARMHostCPUFeatures *ahcf)
 {
     /* Identify the feature bits corresponding to the host CPU, and
      * fill out the ARMHostCPUClass fields accordingly. To do this
      * we have to create a scratch VM, create a single CPU inside it,
      * and then query that CPU for the relevant ID registers.
-     * For AArch64 we currently don't care about ID registers at
-     * all; we just want to know the CPU type.
      */
     int fdarray[3];
     uint64_t features = 0;
+    int err;
+
     /* Old kernels may not know about the PREFERRED_TARGET ioctl: however
      * we know these will only support creating one kind of guest CPU,
      * which is its preferred CPU type. Fortunately these old kernels
@@ -487,8 +510,71 @@ bool kvm_arm_get_host_cpu_features(ARMHostCPUFeatures 
*ahcf)
     ahcf->target = init.target;
     ahcf->dtb_compatible = "arm,arm-v8";
 
+    err = read_sys_reg64(fdarray[2], &ahcf->isar.id_aa64pfr0,
+                         ARM64_SYS_REG(3, 0, 0, 4, 0));
+    if (unlikely(err < 0)) {
+        /*
+         * Before v4.15, the kernel only exposed a limited number of system
+         * registers, not including any of the interesting AArch64 ID regs.
+         * For the most part we could leave these fields as zero with minimal
+         * effect, since this does not affect the values seen by the guest.
+         *
+         * However, it could cause problems down the line for QEMU,
+         * so provide a minimal v8.0 default.
+         *
+         * ??? Could read MIDR and use knowledge from cpu64.c.
+         * ??? Could map a page of memory into our temp guest and
+         *     run the tiniest of hand-crafted kernels to extract
+         *     the values seen by the guest.
+         * ??? Either of these sounds like too much effort just
+         *     to work around running a modern host kernel.
+         */
+        ahcf->isar.id_aa64pfr0 = 0x00000011; /* EL1&0, AArch64 only */
+        err = 0;
+    } else {
+        err |= read_sys_reg64(fdarray[2], &ahcf->isar.id_aa64pfr1,
+                              ARM64_SYS_REG(3, 0, 0, 4, 1));
+        err |= read_sys_reg64(fdarray[2], &ahcf->isar.id_aa64isar0,
+                              ARM64_SYS_REG(3, 0, 0, 6, 0));
+        err |= read_sys_reg64(fdarray[2], &ahcf->isar.id_aa64isar1,
+                              ARM64_SYS_REG(3, 0, 0, 6, 1));
+
+        /*
+         * Note that if AArch32 support is not present in the host,
+         * the AArch32 sysregs are present to be read, but will
+         * return UNKNOWN values.  This is neither better nor worse
+         * than skipping the reads and leaving 0, as we must avoid
+         * considering the values in every case.
+         */
+        err |= read_sys_reg32(fdarray[2], &ahcf->isar.id_isar0,
+                              ARM64_SYS_REG(3, 0, 0, 2, 0));
+        err |= read_sys_reg32(fdarray[2], &ahcf->isar.id_isar1,
+                              ARM64_SYS_REG(3, 0, 0, 2, 1));
+        err |= read_sys_reg32(fdarray[2], &ahcf->isar.id_isar2,
+                              ARM64_SYS_REG(3, 0, 0, 2, 2));
+        err |= read_sys_reg32(fdarray[2], &ahcf->isar.id_isar3,
+                              ARM64_SYS_REG(3, 0, 0, 2, 3));
+        err |= read_sys_reg32(fdarray[2], &ahcf->isar.id_isar4,
+                              ARM64_SYS_REG(3, 0, 0, 2, 4));
+        err |= read_sys_reg32(fdarray[2], &ahcf->isar.id_isar5,
+                              ARM64_SYS_REG(3, 0, 0, 2, 5));
+        err |= read_sys_reg32(fdarray[2], &ahcf->isar.id_isar6,
+                              ARM64_SYS_REG(3, 0, 0, 2, 7));
+
+        err |= read_sys_reg32(fdarray[2], &ahcf->isar.mvfr0,
+                              ARM64_SYS_REG(3, 0, 0, 3, 0));
+        err |= read_sys_reg32(fdarray[2], &ahcf->isar.mvfr1,
+                              ARM64_SYS_REG(3, 0, 0, 3, 1));
+        err |= read_sys_reg32(fdarray[2], &ahcf->isar.mvfr2,
+                              ARM64_SYS_REG(3, 0, 0, 3, 2));
+    }
+
     kvm_arm_destroy_scratch_host_vcpu(fdarray);
 
+    if (err < 0) {
+        return false;
+    }
+
    /* We can assume any KVM supporting CPU is at least a v8
      * with VFPv4+Neon; this in turn implies most of the other
      * feature bits.
-- 
2.17.2