The last line showed is "Freeing unused kernel memory: 156k freed". I had to kill the qemu session from another terminal. But I did see the following lines during its boot-up:
Console: ttyS0 (SunZilog zs0) ttyS0 at MMIO 0x0 (irq = 44) is a SunZilog ttyS1 at MMIO 0x0 (irq = 44) is a SunZilog
However, if I remove "console=ttyS0" from the qemu command line, it boots up and I can get the command line prompt as follows (I got the same "Console: ttyS0 (SunZilog zs0)" message (listed above)):
... Freeing unused kernel memory: 156k freed sh: can't access tty; job control turned off # ls /dev console ttyS0 ttyS1 ttyS2 ttyS3 #
Can someone tell me the reason? Also how do I get rid of the message "sh: can't access tty; job control turned off" (and what it means?) ?
Thanks in advance! Wesley
P.S. Please reply me directly as I am not in the alias.